SPEAKER LOST MUSIC? HOW TO FIX

Troubleshooting Smart Speakers Losing Sound

Portable speakers are convenient devices that provide hours of entertainment. However, it can be frustrating when the sound cuts out while singing, leaving you unsure how to fix the issue. The following article from Điện máy XANH will guide you through this!

01. Causes of Portable Speakers Losing Sound

There are many reasons why a portable speaker may lose sound, typically due to the following:

• Unstable Power Source:
  The power plug may be unstable, or the power cable may be dirty or loose, leading to limited contact. As a result, the sound may be distorted, and music may cut out while singing, or the music signal may be intermittent.

• Electrical Issues:
  Another common cause is issues with the electrical power supply. If the signal cable system has exposed wires or is damaged, it affects the speaker’s ability to play music, leading to sound loss when singing.

• Incorrect Connection Ports:
  Many new users may not be familiar with the device and may plug into the wrong connection port, which would prevent sound from being played through the speaker.

• Weak Battery:
  If you have been using the portable speaker for an extended period without charging it, it may run out of battery, resulting in a low battery warning followed by loss of sound. Typically, current portable speakers can be used continuously for a maximum of 4 to 6 hours, depending on the volume level and different brands.

• Internal Component Failure:
  If your speaker can only play microphone audio or music but not both simultaneously, it could indicate an internal component failure, which is quite complex and may require professional repair.

• Incorrect Speaker Mode:
  If your speaker is losing sound, check if the mode being used is correct. Some portable speakers have a “MC” mode that allows only microphone use, preventing music playback.

02. Simple Fixes for Portable Speakers Losing Sound at Home

You can troubleshoot a portable speaker losing sound at home using the following methods:

• Check the Audio Source:
  Inspect the connection ports for any looseness or damage. If you notice that the audio connection port is loose or oxidized, you should replace it immediately to resolve the sound loss issue. Then, turn off the speaker, wait for a moment, and restart it.

• Check Connection Ports:
  If you have connected the wrong ports, the solution is simple. Unplug the previous connections and then plug them back in according to the labels on the back of the speaker, and turn the speaker back on to check.

• Check Battery Level:
  If the sound cuts out while singing, check if the speaker battery is low or dead. If it is, charge the speaker, typically for 6 to 8 hours for a full charge. Also, avoid charging overnight, as this may damage or degrade the battery.

• Set the Correct Speaker Mode:
  For issues caused by selecting the wrong speaker mode, follow these steps:

  1. Turn off the speaker and let it rest for a few minutes.

  2. Restart the speaker.

  3. Press the MIC PRIORITY or MIC.PRI button. Some models have “ON/OFF” written on them.

  4. Play music again and check with the microphone.

In cases where the portable speaker has electrical issues or internal component failures, you cannot fix it at home. You will need to take it to a repair shop for professional assistance. Avoid attempting to disassemble or fix it yourself if you lack knowledge of electronic components, as this may cause further damage.

03. Some Tips When Troubleshooting Portable Speakers Losing Sound

When a portable speaker loses sound, keep the following tips in mind:

• Before investigating the causes, try turning the power off and on a few times to see if the speaker functions normally.

• Next, check the battery, audio source, mode, and connection ports to easily identify the cause.

• Replace cables with high-quality products.

• Clean the portable speaker after long-term use. Use cleaning solutions suitable for electronic devices and a dry cloth to wipe and clean.

• Absolutely avoid disassembling the inside of the portable speaker for repairs or replacements if you do not have sufficient knowledge of electronic components.